Supports country-level targeting

1.You must add your local IP and the IP you want to use to the whitelist

a. Add the IP to the whitelist - this method does not require a username and password. We will automatically obtain your device IP and add it, which is enabled by default.

b. Add whitelist IP-Fill in detailed information to add to the whitelist. After adding, it will be displayed in the whitelist selection according to the on/off status selected when adding.

2.Whitelist selection - Here the whitelist IPs of the added supported countries are displayed. The checked state is enabled, and the IP+port generated by the configuration can be connected normally to access the target website. The unchecked state is disabled, and the IP+port generated by the configuration cannot access the target website.

If you uncheck or check the status here, the IP status in the whitelist will change synchronously

3.Select Location Settings - Select the country to obtain the location, and click Save to take effect.

4.Session type selection - supports two types: sticky and rotating. Select Sticky to keep the IP address fixed for 10 minutes; Select Rotation to return a new IP address for each request.

5.Select output format - supports common formats and API links.

a. General Format - Contains the general default format, http protocol and socks5 protocol. Select the supported protocol, enter the number of endpoints you need, and then select the format you want to export, or copy it directly to the clipboard.

b. API link - you can change the parameters according to the instructions.